product specifications: 300w ~ 400w ac - dc active pfc switching power supply prl1201d dual output series input voltage: 90 ~ 264vac full range, 47 ~ 63hz. input current: 6a at 90vac full load. inrush current: 70a peak maximum.(measuring at 230vac and full load cold start.) power factor correction : pass en61000 - 3 - 2 class d transient response: returns to within 1% in less than 2.5ms for a 50% load change and the peak transient does not excess 5%. overshoot: turn - on & turn - off not exceed 5% over nominal voltage. efficiency: 80% minimum (measuring at 115v and full load) turn on delay : 2 second maximum at 115 vac. hold up time: 16 m sec. minimum at 115vac and 75% of rated maximum load. adjustability: output user adjustable +/ - 5% minimum. remote on - off: designated as rsw on the cn3, requires a low signal to inhibit output. power supply on: when the bi - color led emit green light that indicates the supply is operating. when any protection is occurred or rsw is applied a low signal, the bi - color led will emit orange light. power good: designated as pg on cn3. this signal will go high 100 - 500 msec after the output reaches the regulation limit. it goes low at least 1 msec before loss of regulation and has ability to sink 100ma. input circuit protection (primary): one t6.3a/250v fuse inserted. input voltage protection: power shut down under 80 +/ - 10vac, and recovered over 90 vac. over - power protection: 110~140% of the rated output current and recovers automatically . over - voltage protection: latching down will occur when output voltage exceed 130% max., and recycle ac input to reset. over temp. protection: protected at ambient 110 +/ - 5 ; auto - recovery. short circuit protection: trip without damage and auto - recovery. operating temperature: 0 to +50 switching frequency: pfc 60k hz; pwm 27k hz. storage temperature: - 20 to +85 degrees c. operating humidity: 5% to 90% rh, non - condensing. storage humidity: 5% to 95% rh, non - condensing. vibration: frequency 5 to 50 hz, acceleration +/ - 7.35 m/(sxs) on x,y and z axis. emc: en55022 class b conducted / radiated, en61000 - 3 - 2, en61000 - 3 - 3; en55024 (iec61000 - 4 - 2, iec61000 - 4 - 3, iec61000 - 4 - 4, iec61000 - 4 - 5, iec61000 - 4 - 6, iec61000 - 4 - 11). safety: approved ul60950 - 1, csa c22.2 no. 950 - 95, en60950 and cb certificate available leakage current: < 500ua at 240vac hi - pot test: 1500 vac between input line and chassis (10ma ac cut off current); 3000vac between primary and secondary windings; primary to core 1500vac. all for 3 sec. grounding test: apply 25 a from ground pin to the earthed connection point. maximum allowable resistance is 0.1ohm. warranty: 2 years. mtbf: 100000 hrs (according to mil - hbk - 217f) at 30 . burn in: 45 +/ - 5 degree c for 1 hour @230vac with full load. weight: 1kg copy right ultra level tech co., ltd 2015, all right reserved. specifications subject to change without notice. ultra level tech co., ltd. we supply the power customers need iso9001 www.ultralevel.com.tw tel:+886 - 2 - 29180118 fax:+886 - 2 - 29181465 u type (u - chassis only): 5( w ) x 8( l ) x 1. 6( h ) inches. features: 400w convection cooling with 1u height
note: * prl1201d series are designated as prl1201d - y where y can be 0512,0524,1224 * 10% minimum load is required for all outputs to maintain the ripple and regulation output is fully isolated * total combined power of v1 and v2: 400w max. for prl1201d - 1224 convection cooling. 300w max. for other models convection cooling. * ripple and noise is measured from 10khz to 20mhz bandwidth at output terminals with parallel 0.1f ceramic and 22f electrolytic capacitors. output voltage / current rating chart: measured at output power connector. model number output voltage output current total regulation ripple & noise max. load convection prl1201d - 0512 v1: +5v 35a +/ - 5% +/ - 1% v2: +12v 16.67a +/ - 5% +/ - 1% prl1201d - 0524 v1: +5v 35a +/ - 5% +/ - 1% v2: +24v 8.33a +/ - 5% +/ - 1% prl1201d - 1224 v1: +12v 25a +/ - 5% +/ - 1% v2: +24v 12.5a +/ - 5% +/ - 1% copy right ultra level tech co., ltd 2015, all right reserved. specifications subject to change without notice. ultra level tech co., ltd. we supply the power customers need iso9001 www.ultralevel.com.tw tel:+886 - 2 - 29180118 fax:+886 - 2 - 29181465 outline drawing: prl1201du series (u - chassis type): 8 (l) x 5(w) x 1.6(h)inches; weight: 1kg cn1 b: mounting hole 8 place 6-32 unc(zn-plated) scale 4:1 b c:mounting hole 8 place m4x0.7 (brass) scale 4:1 c c b c b c b c b c b b c b c rtn v1 v2 cn3 rtn pg rsw molex part no. 09-50-3071 (7 pins, 5 used) pin no.3,6 nc terminal block 3pins 9.5mm center l n terminal block 6pins 9.5mm center v1 rtn cn3 cn2 optional connector molex part no. 09-50-3141 (14 pins) v2
i/o connector pin assignment: ac input connector(cn1): mating molex part no. 09 - 50 - 3071 or equivalent (7 pin,5 used) howder terminal block part no. hd - 121 - 3p output connector (cn2): howder terminal block part no. hd - 121 - 6p mating molex part no. 09 - 50 - 3141 (14 pin) output pin assignment: (see below table). logic signal connectors (cn3) : mating jst xhp - 3 or equivalent (chyao shiunn js - 1001 - 03) mating pins: jst sxh - 002t - p0.6 for awg 30 to 26 pin1: pg pin2: rtn pin3: rsw mounting inserts: 6 - 32, m4 4places individually with maximum penetration 0.15 on bottom side and 0.25 on both side v1+ v0 - v2+ molex pins 1 - 5 pins 6 - 11 pins 12 - 14 howder pins 1 - 2 pins 3 - 5 pins 6 copy right ultra level tech co., ltd 2015, all right reserved. specifications subject to change without notice. ultra level tech co., ltd. we supply the power customers need iso9001 www.ultralevel.com.tw tel:+886 - 2 - 29180118 fax:+886 - 2 - 29181465
|
